Battery gauge suddenly drops-check gauge light comes on. I have a 97 jeep tj, 2.5L. It was running great, parked it to run in the house for a few minutes, went and started it up and, everything was normal, then all the sudden the battery volt meter dropped to 9 and the check gauge light came on. I did a code read out by turning the key three ABS would come on at startup and stay on, and SVC 4WD would come on intermittently. The dealer first replaced a rear wheel sensor, which did not work, and finally replaced the ABS module with success. The dealer said that indicator lights would not come on with the hood raised, and concluded it was normal engine heat causing problems with one The FCW is not supposed to be speed dependent. As I understand it from the manual, FCW may not activate or trigger a warning if you are braking. It may depend on whether or not you are braking enough to avoid hitting the object in front of you. The contact owns a 2003 Jeep Grand Cherokee. The contact stated that when the turn signal was activated, the exterior and interior indicators failed to illuminate. The failure occurred intermittently. The dealer was unable to diagnose the cause of failure. The current mileage is 58,000 and failure mileage was 50,000. At speeds over 40 mph (64 km/k), the system automatically switches to “Partial Off” mode, described above. When the vehicle speed returns to less than 35 mph (56 km/h), the ESC system will return to “Full Off” mode. The “ESC Activation/Malfunction Indicator Light” is always illuminated when ESC is off. . Electrical issue on Dash Jeep GC 2006. Got a 2006 Jeep Grand Cherokee. I have been having issue with indicator sensors coming on the dash while driving. I will driving and then the dash will ding to notify me that a sensor indicator has come. It won't always be the same sensor. Battery gauge suddenly drops-check gauge light comes on. I have a 97 jeep tj, 2.5L. It was running great, parked it to run in the house for a few minutes, went and started it up and, everything was normal, then all the sudden the battery volt meter dropped to 9 and the check gauge light came on. I did a code read out by turning the key three Check the Connections. In order to replace your bulbs, you had to access the back of the turn signal housings. Also in this location, you'll find the plugs that connect your tail lights and front turn signals to the car's electrical system. Unplug these and plug them back in one at a time. Sometimes just the act of unplugging and replugging can 11 posts · Joined 2012. #4 · Jan 17, 2015. Dealer said that the new TIPM wires differently. They switched pins 7 and 11 and now it works great again. Hopefully that will be the last problem. Sent from my iPhone using JeepGarage. 2012 WK2 Overland, 5.7L V8 HEMI, Black Forest Green; 2005 WK Limited, 5.7L HEMI, Black; father-n-laws 1949 CJ3a 13939 Airline Hwy. Baton Rouge, LA 70817. Sales: 225-577-5355. Service: 225-478-5541. 225-412-2251. Get Directions Why Us Contact Us. Regular Jeep maintenance helps your vehicle avoid road problems. However, you should still keep an eye out for Jeep dashboard symbols that indicate it needs repairs.

jeep grand cherokee indicators not working